<div dir="ltr"><div><div><div>I will start out by saying I am not an EnergyPlus expert.
 I am trying to convert one of the DOE commercial building E+ prototypes
 from a CAV system to a VAV system to determine the energy savings. I 
have modified the baseline CAV model for one of the zones thus far to a 
VAV system, but the VAV model is using more energy than the CAV model. I
 also have a lot more unmet hours for both heating and cooling. I cannot
 figure out what is causing these issues (I assume they are related). My
 current guess is that I continue to use the same cooling coil 
(Coil:Cooling:DX:SingleSpeed) in the VAV model, rather than converting 
the coil to Coil:Cooling:DX:TwoSpeed as I see in most of the other DOE 
prototype VAV models.<br>
<br></div>My questions are:<br>1. Is it ok to use the Coil:Cooling:DX:SingleSpeed in a VAV system, or should I convert that to a Coil:Cooling:DX:TwoSpeed?<br></div>2.
 If it I convert the VAV model to the Coil:Cooling:DX:TwoSpeed is this 
analogous to modifying the baseline compressor to a variable speed 
compressor?<br>
<br></div>Thanks for any help.<br>Ryan</div>