Hello everyone,<div><br></div><div>I'm using E+ example file to test the output of E+ ideal load system output. </div><div><br></div><div>In the input/output reference, it says that "the Ideal Loads Total Cooling Energy + Ideal Loads Heat Recovery Total Cooling Energy = Ideal Loads Zone Total Cooling Energy+ Ideal Loads Outdoor Air Total Cooling Energy", but I found it goes wrong when I add a DesignSpecification:OutdoorAir into the Ideal load system. The Ideal Loads Zone Total Cooling Energy+ Ideal Loads Outdoor Air Total Cooling Energy sometimes is higher than the  Ideal Loads Heat Recovery Total Cooling Energy( which is always 0 in this case) +Ideal Loads Total Cooling Energy. Attachment is the simulation file. Can someone please help me solve this problem? Thank you very much.</div>
<div><br></div><div>Best,</div><div><div><br></div><br><div>Yuna Zhang</div>
<div><br></div><div>Ph.D student in Building Technology </div>
<div>College of Architecture</div>
<div>Georgia Institute of Technology<br>Atlanta, USA</div><br>
</div>