<div>Dear all,</div>
<div> </div>
<div>when modelling an active layer, there is a bunch of issues coming up:</div>
<ol>
<li>piping distance must be equal to or higher than 7 cm --> is there a way to model 5 cm?</li>
<li>the pipes must be embedded in twice the same layer, i.e. the one above the active layer equals the one below, except for the thickness --) how can I model a case where the layer above has a very small thickness (like 1 cm)? There is a limit that is higher than that ... which I assume has to do with numerical stability ...</li>

<li>there is a limit on the thickness for layers ... which I can get. Only issue than is the modelling of a thin bitumen layer of 2 mm is impossible --> solution?</li></ol>
<div>Any suggestions on how to solve those?</div>
<div> </div>
<div>thanks already</div>