<div>Hi Chris, </div>
<div> </div>
<div>I did not pay attention to the air temperatures in the three equivalent zone. The original purpose was to test whether those "virtual partition" is IR transparent. If they were, the overall sensible cooling/heating capacity would be affected. </div>

<div> </div>
<div>Then I looked into those temperatures after reading your email. Basically , the temperatures are represented in a 'beautiful' stratified manner. MRTs are in the same manner, and divergence wise, no significant difference compared as air temperatures. </div>

<div> </div>
<div>I do not expect a simulation engine can trace the complication of the physical state. The assumption behind the simulation engine is that, air within the space is well stirred and represented by a single air temperature. In order to see the stratified effect in some big space or displacement ventilation effect, we refine the single space and come up with more sub-space by "virtual partition". Air within each of the sub-zone is well stirred but they are interacting with each other through the boundaries, virtual partition. </div>

<div> </div>
<div>From research point of view, simulation is not a convincing tool at all, even the most robust CFD simulation. I'd rather set up experiment and filed measurement to explore specific physical state. Project wise, I believe the assumption is fairly acceptable. Bear in mind, there are many other assumptions which are rougher than this one but still survive.      </div>

<div><br><br> </div>
<div><font face="comic sans ms,sans-serif">Regards, </font></div>
<div><font face="comic sans ms,sans-serif"></font> </div>
<div><font face="comic sans ms,sans-serif">Cheney</font></div>
<div><font face="comic sans ms,sans-serif"></font> </div>
<div><font face="comic sans ms,sans-serif">LinkedIN @ </font><a href="http://ca.linkedin.com/pub/yu-cheney-chen/27/637/72b" target="_blank"><font face="comic sans ms,sans-serif">http://ca.linkedin.com/pub/yu-cheney-chen/27/637/72b</font></a><font face="comic sans ms,sans-serif"> </font></div>
<br>