<div>Hello All,</div>
<div>              I am modelling a heat pipe in the parametric runs (<em>my system has a Make-up air unit and I am adding a heat pipe to it</em>). The Inputs eQUEST asks for the following:</div>
<div> </div>
<div>(1) <strong>Sensible Effectiveness</strong>: I inputting a value of 0.48.</div>
<div> </div>
<div> </div>
<div>(2) <strong>Frac. Sensible HX Resistance from Air Films</strong>: The heat pipe manufacturer does not any thing about this coefficient neither they list in the catalog. I tried varying the resistance values from 0 to 1 in incerments of 0.1 - Once I simulate the parametric runs, there are zero savings from this measure</div>

<div> </div>
<div>(3) <strong>Exponent Varying Sensible Air films Resistance</strong>: I varied the values from 0 to 1 in terms of 0.1. My understanding is that the flows in the Make up unit are turbulent and hence there has to some number to this exponent.</div>

<div> </div>
<div>After I varied these values, and I simulate the parametric runs, there are zero savings from this measure. The reason I varied these values was that there were zero savings even for the single value input. I am looking for little guidance. Any help is appreciated. Thanks in advance!</div>

<div> </div>
<div>Kazim Mirza</div>
<div>Energy Engineer</div>
<div>EMCOR Energy Services </div>
<div> </div>