<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"><HTML DIR=ltr><HEAD><META HTTP-EQUIV="Content-Type" CONTENT="text/html; charset=iso-8859-1"></HEAD><BODY><DIV><FONT face='Arial' color=#000000 size=2>Dear all:</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>Does anyone have suggestions or experience on these
two issues?</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>1) My eQuest case is created using an INP file.
After I change in the Detailed Data Edit mode and ran it, the Export Hourly
Results was grayed out. Is there a way to get the 8760 data output?</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>2) In a different file, I am trying to create
a water source heat pump which supplies hot water for radiant heating. No matter
how I set the loop and the heat pump temperature, I kept getting this
message</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial
size=2>***ERROR***********************************************************************<BR>
In
zone-sp-1-1F_Core
, heating coil
leaving<BR>
temperature must be at least 10F lower than
entering<BR>
water temp. EWT = 100.0 LAT = 112.0<BR></FONT></DIV>
<DIV><FONT face=Arial size=2>What should I change to resolve this problem?
</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>Thanks a lot.</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>-Jifeng Zhang</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT><FONT face=Arial size=2>United Technologies
Research Center</DIV></FONT><PRE>
===========================
You received this e-mail because you are subscribed
to the BLDG-SIM@GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE@GARD.COM
</PRE></BODY></HTML>