<html>
<body>
I received an email from Jeff Hirsch. DOE2.1e does not support two
hydronic loops. The heat pump loop is a separate loop even when
using FROM-PLANT. Therefore you can't also have hydronic baseboards
or a hydronic make-up air system. One would need to use
DOE2.2. Apparently it is time for me to climb that learning
curve. <br><br>
At 09:51 2007-03-26, Chris Jones wrote:<br>
<blockquote type=cite class=cite cite="">
<font face="Courier New, Courier">I am modelling an HP system using the
heating and cooling FROM-PLANT. This works fine unless I try adding
hydronic baseboards. DOESIM crashes. If I use electric
baseboards it runs fine. I am using DOE-2.1En136 from
DOE2.com.<br><br>
Has anyone had any experience with this problem?<br><br>
<br><br>
<br>
Chris Jones, P.Eng.<br>
14 Oneida Avenue<br>
Toronto, ON M5J2E3<br>
Tel. 416 203-7465<br>
Fax. 416 946-1005</font><br>
<pre>
======================================================
You received this e-mail because you are subscribed
to the BLDG-SIM@GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE@GARD.COM
</pre><font face="Courier New, Courier"></blockquote>
<x-sigsep><p></x-sigsep>
<br>
Chris Jones, P.Eng.<br>
14 Oneida Avenue<br>
Toronto, ON M5J2E3<br>
Tel. 416 203-7465<br>
Fax. 416 946-1005</font><PRE>
======================================================
You received this e-mail because you are subscribed
to the BLDG-SIM@GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE@GARD.COM
</PRE></body>
</html>