[BLDG-SIM] cannot meet ASHRAE 90.1 required hours

Tue Aug 14 05:36:28 PDT 2007

In that case, what I did after that was lower or raise the cfm to these
spaces.

-----Original Message-----
From: BLDG-SIM at gard.com [mailto:BLDG-SIM at gard.com] On Behalf Of
yizhao1 at vt.edu
Sent: Monday, August 13, 2007 5:38 PM
To: BLDG-SIM at gard.com
Subject: [BLDG-SIM] cannot meet ASHRAE 90.1 required hours

Yes, I did changed individual zone capacity, and it is the cooling loads in
the
internal zones cannot be met.

Quoting Kevin Kyte <kkyte at robsonwoese.com>:

> Try increasing the individual zone capacity.  Does the building have
> baseboard heating? Try increasing this also, if applicable
>
> -----Original Message-----
> From: BLDG-SIM at gard.com [mailto:BLDG-SIM at gard.com] On Behalf Of
> yizhao1 at vt.edu
> Sent: Monday, August 13, 2007 3:09 PM
> To: BLDG-SIM at gard.com
> Subject: [BLDG-SIM] cannot meet ASHRAE 90.1 required hours
>
> Hi all-
> I'm runing a simulation with eQuest for a baseline required by ASHRAE
90.1.
> system type 7, VAV w/reheat iis used. I've increased the heating and
cooling
> capacity of VAVs significanlty, but the umet hours are still exceed the
> requirements, and do not change much as I change the heating and cooling
> capacity of the VAV system.
> Do you know what the problem is? Any susgestion would be helpful!
>
> Thanks in advance!
>
> Ying Zhao
>
>
>
>
> ======================================================
> You received this e-mail because you are subscribed
> to the BLDG-SIM at GARD.COM mailing list.  To unsubscribe
> from this mailing list send a blank message to
> BLDG-SIM-UNSUBSCRIBE at GARD.COM
>
>
>

======================================================
You received this e-mail because you are subscribed 
to the BLDG-SIM at GARD.COM mailing list.  To unsubscribe 
from this mailing list send a blank message to 
BLDG-SIM-UNSUBSCRIBE at GARD.COM