[bldg-sim] eQUEST results

[Samuel Casado]

Dear bldg-sim users,

I'm trying to size the HVAC equipment in a office in different
situations, bu t I get contradictorial results. Which is the best
procedure in such calculations in equest? Is it enough just selecting
"auto-size" in package HVAC equipment? Where can we find the load
calculation results sheet in D2SimViewer?

When adding a layer of insulation to an old non-insulated dwelling (with
high inertial mass), I get that the savings in heating are not enough to
compensate the rise in cooling demand (and electricity bill). I'm a bit
confused there because in my understanding adding insulation would cut
down heating deamand, and shoul had little or no effect on cooling
season. Had anyone crossed over with the same problem? If anyone had a
paper on the subject, I'll appreciate any information.

Regards,

Samuel Casado González
Aspica Constructora
47001 VALLADOLID
España




===========================
You received this e-mail because you are subscribed 
to the BLDG-SIM at GARD.COM mailing list.  To unsubscribe 
from this mailing list send a blank message to 
BLDG-SIM-UNSUBSCRIBE at GARD.COM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20050119/4ba691cc/attachment.htm>