[Equest-users] How to Change the building orientation in detailed mode

[Patrick J. O'Leary, Jr.]

it is much easier to create 3 parametric runs, one with each of the 
rotations.  see attached document.  i typically name mine 90, 180, and 
270 (instead of the 1, 2, 3 in the example) just to be clear which 
orientations are being compared in the comparison reports.

when you simulate the building just make sure all of the parametric runs 
are checked and equest will simulate your base rotation and the 90, 180, 
270 at the same time.

On 7/15/10 1:32 PM, Ming Li wrote:
>
> Hi All,
>
> I am trying to model a baseline design. I need to simulate the 
> building with its actual orientation and again after rotating the 
> entire building 90, 180, 270 degrees, then averaging the results. I 
> was wondering if I can change the building orientation in detailed 
> mode so that I do not need to go back to Wizard mode. Does anyone know 
> how to do this?
>
> Thanks,
>
> Ming Li, LEED AP
>
>
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
>    

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20100715/a89626dd/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Building Rotation.pdf
Type: application/pdf
Size: 47122 bytes
Desc: not available
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20100715/a89626dd/attachment.pdf>